A surface burner that clicks without lighting, or does not click at all, is a common range and cooktop call in Englewood Cliffs kitchens running Wolf, Viking, and Thermador cooking. The fault usually traces to the igniter, the spark module, or the burner itself.
Notes by Brand
The same symptom shows up differently across brands. Here is how we approach burner not igniting on the units we service most:
- Wolf: A burner that clicks but will not light is often a wet or dirty igniter cap or a failed spark module. We dry and clean the cap and test the module.
- Viking: Check the igniter cap, the spark switch, and the module. A worn switch can stop the spark entirely.
- Thermador: On sealed burners, a wet cap or a clogged port is common. Freedom induction faults are different and point to the board.
- La Cornue: A burner that will not light can be a dirty igniter, a blocked port, or a gas-supply issue. We clean and verify the gas path.
- Dacor: Test the spark module, the switch, and the electrode. A cracked electrode stops ignition on that burner.
- Monogram: Check the igniter, switch, and module. GE-platform ranges respond to cap cleaning and module testing.
- KitchenAid: A burner that will not spark points to the igniter switch, the module, or a wet cap. We test the electrical path.
Symptoms, Causes & Checks
| Symptom | Likely Cause | What We Check |
|---|---|---|
| Clicks, no flame | A wet or dirty igniter, or a gas fault | Dry and clean the cap, verify the gas path |
| No click | A failed spark module or switch | Test the module, switch, and electrode |
| One burner only | A cracked electrode or blocked port | Inspect the electrode and clean the port |
Safety first: If you smell gas, do not try to light the burner. Turn it off, ventilate the room, and book service so we can inspect the burner and gas path safely.
Book a diagnosis for this problem